Open the full tool →

Free image vectorizer

A photo, a logo, a pencil drawing you snapped: here it becomes a contour in millimetres, ready for the laser. You set it by looking, and the image is never uploaded — the tracing happens inside your own browser.

Image

—

Or drag it onto the page, or paste it with ⌘/Ctrl+V.

What comes out

Size

0.15 mm

Reading

1
128
0

Other settings
0
1

Machine limits

This page assumes a 0.20 mm kerf: inside Plyjoin your own project's kerf applies.

2 mm²
2 mm²
1 mm
—1 part · cut file
Carry on in Plyjoin

The preview is free. Downloading the file asks for a free account: one e-mail, no card.

The image never leaves

There is no upload: your browser reads the file and your own computer does the tracing. What you download is the only thing that comes out, and you are the one downloading it.

What falls, falls

The hole in an “o” is not a drawing: it is a piece that comes loose and drops to the bottom of the machine. Here you see it first, and the tabs hold it to the sheet.

Millimetres, not pixels

The width you set is the width of the DRAWING, not of the file: a logo with air around it will not come out smaller than you asked. And the downloaded file is in real millimetres. For the warnings above this page assumes a 0.20 mm kerf; inside Plyjoin your project's own kerf applies.

How the vectorizer works

The image is read pixel by pixel and split into levels: by lightness, or by colour if you ask for it. Around each level the contour is traced, simplified down to the detail you chose, and measured in millimetres. This is not an “auto-trace” that guesses: every setting you touch changes the drawing in front of you, and the numbers under the preview tell you how many contours, how many holes, how long the path is and how long the cut will take.

Which files can I use?

PNG, JPEG, WebP, GIF, BMP and even SVG, as long as it carries a size. A line drawing is recognised on its own and smoothing switches off, because on a thin stroke it would eat the curls. A photograph is better kept smoothed: pixel noise, left alone, turns into hundreds of tiny islands to cut.

What if I need to touch it up?

The contours do not stay an image: opened in Plyjoin they become a real part, with points to move, holes to close, joints to add and the thickness of your material. The cut file comes out of there, from the same engine that made the preview.